Garbage truck, sweeper, sprinkler details should pay attention to matters

1. Garbage trucks, road sweepers, and more water as much as possible
If garbage trucks, road sweepers, sprinklers have too much oil, garbage trucks, road sweepers, and sprinkler truck engines are cranking and the connecting rods are violently agitated during operation, not only increasing the internal power loss of the engine, but also causing splashes. The oil on the cylinder wall increased, causing burnout oil failure. Therefore, the amount of oil in garbage trucks, sweepers, and sprinklers should be controlled between the upper and lower mark lines of the oil dipstick.

2, garbage trucks, sweepers, sprinkler bolts as tight as possible
Garbage trucks, road sweepers, and sprinklers have many fasteners connected by bolts and nuts. They should be guaranteed to have sufficient preload, but they cannot be tightened too tightly. If the tightening is too tight, on the one hand, the coupling will be permanently deformed under the action of external force; on the other hand, it will cause the permanent deformation of the bolts of the garbage truck, sweeper truck and sprinkler truck, and the pre-tightening force will drop, even cause Slipping or breaking phenomenon.

3, garbage truck, sweeper, sprinkler drive belt tighter the better

Garbage trucks, sweepers, sprinkler engines, pumps and generators are driven by a V-belt. If the garbage trucks, sweepers, sprinkler belts are over-tightened and easily stretched, the belt pulleys and bearings can easily bend and damage. Garbage trucks, road sweepers, and sprinkler belts should generally be adjusted so that the amount of subsidence is between 3% and 5% of the center distance of the pulleys at both ends.

Cap ridge roll forming machine

Guard Rail Roll Forming Machine,Guard Forming Machine,Rolling Machine

Botou Zhenyuan Roll Forming Machine Factory , http://www.hb-rollformingmachine.com