Fingerprint Folding Lock smart lock for bike, ebike, motorcycle WENZHOU JINJIAN SMART LOCK CO.,LTD , https://www.jinjianlocks.com
First, if the float is not moving, the float inside the tube will not move, the follower magnet will not move, and the pointer of the metal tube float flow meter will not move. Therefore, the float inside the metal tube float flowmeter should be taken out to analyze the reason why the float was stuck.
(1) The deformation of the float caused by the stop deformation is caused by the inattentiveness of the worker, and the valve is opened and closed quickly, causing the pressure of the flowmeter to be too large and the flowmeter to be deformed. The deformation of the stop will make the float unable to move and the pointer will not move. Look at the contrast chart in the figure below. The next two are deformation stops.
(2) The degree of cleanliness of the medium causes the float of the floater's stuck metal tube float meter to jam, and also relates to the cleanliness of the medium. Because of the magnetic steel in the float, if the medium contains iron cut, it will be absorbed by the float, so the float will be stuck. Some tiny particles will also make the floats inflexible and get stuck, so remove the floats and clean them up.
Second, the medium pressure is too small to cause the float to be jacked up. Because the principle of the metal tube float flow meter is installed vertically, the floater has a certain amount of gravity. If the medium pressure is too low, the natural floater will not stand up and the pointer cannot move with the floater.
Third, inappropriate range selection. Each pipe diameter has a certain measurement upper and lower limits. If the media flow does not reach the lower limit of the flow meter's measurement, the flow meter will not indicate and the pointer will not move.
Changzhou Liangbang Instrument Co., Ltd. specializes in producing metal tube float flowmeters and has rich experience. Every product is of superior quality. Related Products Key words Metal Tube Float Flowmeter with Remote Metal Tube Flowmeter Metal Tube Rotary Flowmeter Metal Tube Float meter signal output
Talking about the Causes of the Pointer Stuck in Metal Tube Float Flowmeter
The metal tube floater flowmeter is based on the magnetic steel in the float and the follower magnet in the indicator, and the rotation occurs and the pointer is rotated. Therefore, the pointer of the float tube of the metal tube is not moving. There are a lot of reasons and it needs to be analyzed. Changzhou Jinger Automation Instrument Co., Ltd. will answer your questions.