After making profits for the month in May, the FAW Liberation Gear Transmission Branch recently reported another victory. The 100,000th gearbox assembly produced this year was off the assembly line C. In the ten years since FAW Liberation Transmission Co., Ltd., its annual output exceeded 100,000 units again. On November 22, 2010, the 100,000th FAW Liberation Gearbox slowly rolled down the assembly line C in 2010. It should come as no surprise that an annual output of 100,000 gearboxes. However, it is of special significance to the development of the FAW liberation gearbox. It marks that after more than three years of hard work, the new product development work and product structure adjustment of FAW Liberation Transmission has achieved a phased success; it marks the beginning of the effectiveness of the first phase, second phase technical transformation investment and productivity improvement of FAW Liberation Gearbox. Significantly, it marks the progress made in the improvement of product quality of FAW Jiefang Transmission Co., Ltd. The user has started to accept FAW's liberation of its own gearbox! According to reports, in 2010, FAW Liberation Transmission will produce and sell 11.5 sets of transmissions. Among them, the output of CA9TB160, CA10TA160 and CA12TA210 series heavy-duty transmissions will exceed 30,000 units. In 2011, the output of FAW’s liberation of its own gearboxes will also increase substantially. The heavy curtain-driven development curtain has been gradually lifted by FAW's liberation gearbox. Thermal spray wires are used in thermal spraying processes, which involve the application of a coating material onto a surface. These wires are specifically designed to be melted and sprayed onto a substrate to create a protective or functional coating. Spray Wires,Arc Spray Coating,Thermal Arc Spray,Thermal Spray Wire Luoyang Golden Egret Geotools Co., Ltd , https://www.hvafspray.com
Thermal spray wires are typically made from materials such as metals, alloys, or ceramics. They are available in various diameters and compositions to suit different applications and requirements. The wire is fed into a thermal spray gun, where it is heated to a molten state and propelled onto the surface being coated.