Routine maintenance of mobile sales vehicles

Although the mobile sales vehicles are relatively new models, they have been used in many places in recent years. Although owners will be busy making money while ignoring the daily maintenance of the vehicle, it is still necessary to understand some routine maintenance points.

 移动售货车

1. After the mobile vending truck has traveled for a long time, pay attention to observing whether the various oils in the vehicle are still sufficient in quantity, and whether or not the quality of the vending truck will pass. During the inspection, we must pay attention to all the parts of the vehicle that need to be used to check the oil, including the engine, water tank, gearbox, etc. When it is found that the fluid is insufficient, it is necessary to supplement the sales truck in time.

2, do not feel that the material of the tire is thick, the use of the rated life can reach several years, and then in the usual time do not go to the daily maintenance of it. In fact, the tires have to bear the weight of the entire sales vehicle. If the tires are not inspected for cracks on the surface of the tires, or if they are embedded in foreign objects, then it is easy to cause tire punctures when accidentally occurs. .

3, to the brake system to do the necessary maintenance work. When carrying out maintenance, be sure to check that all the devices in the entire system, such as car plates and handbrake, are all not damaged due to prolonged use. And after the inspection, it is also possible to start the truck at a very slow speed and then try out the sensitivity of the brake system.

4. For the line circuit of the sales vehicle, if it is desired to extend the time that the sales vehicle can be used properly, then it is necessary to always pay attention to whether the circuit circuit system in the vehicle has a short-circuit and poor contact. If there is a problem with the line circuit, then the lights and meters of the sales vehicle will not be able to operate normally. It is very unsafe to drive on the road without normal instructions.

In addition to the above-mentioned maintenance that should normally be done, for those owners who are located in areas where the conditions are not particularly good, they must pay attention to the use of better-quality fuel to make the vehicle more resistant to explosions. performance.


Boiler Bend


Boiler ElbowBoiler Tube Bend are made form tight radius thick wall tubes used in the boiler industry. We manufacture these heavy-duty machines equipped with a clamping device, which locks the tube into the pressure die and allows the tube to be forced thus reducing wall thinning and ovality.

Seamless Boiler Bend,Stainless Steel Boiler Bend,Boiler Tube Bending,U Bent Tube Boiler

Jinan Yuanda Power Equipment Co.,Ltd. , https://www.ydboilerpart.com