Road sweeper vehicle 10 system operation methods

1, the control box (Figure 6)

The road sweeper control box is located between the two seats in the cab. Except for the tilting of the box and the rear door switch, all operations in the work are performed here.

2, function switch

The road sweeper function switch is located on the underside of the cab dashboard and is divided into upper, middle and lower gears. Upper position: The front of the suction mouth is lifted (in case of large block garbage); the middle position: the execution of the control box instruction, the general operation; the lower position: the temporary suspension of the operation, all the cleaning system is in the recovery position.

3, power take off switch

The road sweeper power take-off switch is on the right side of the steering wheel. Turn on this switch and tilt the hydraulic circuit oil pump in the hydraulic system.

4, manual valve

The road sweeper manual valve group is fixed at the bottom of the left side auxiliary fuel tank. There are two operation handles, one control box on the left and the other control the opening and closing of the rear door.

5, safety bracket (Figure 8)

The safety bracket is located in the middle of the subframe. When a sweeper lifts the box for whatever reason, he should not neglect to prop up the safety rack.

6, swimming hose (user needs, when ordering)

The moving hose is on the top of the box and can be rotated 270 degrees around the car. When it is used, the extension tube is connected. The road sweeper can suck the rubbish that can not be cleaned in the road divider or sidewalk, and can also extend into the well with 2m depth. Sewage sewage.

7, pressure regulator (Figure 9)

The knob of the pressure regulator of the sweeping vehicle is located near the suction opening at both ends of the cross-frame cross beam to adjust the working pressure of the wide brush against the ground.

8, spray gun

The water spray gun is hung above the mudguard on the left rear wheel of the car to flush the tank and the exterior of the car.

9, PC host

All instructions on the control box are handled by a PC and then the electromagnets in the component cabinet are controlled.

10. Component Cabinets (Figure 10a, Figure 10b)

The sweeper component cabinet is located below the sub engine radiator on the right side of the cabinet and is an easily accessible location. Here, almost all the solenoid valves in the hydraulic, pneumatic, and water systems are concentrated. Daily adjustments, inspections, maintenance, and the like of the garbage sweeper are often performed here.