The most important of all that It is available for using and viewing.
Cixi Jinfeng Plastics Co.,Ltd, founded in 2000, is a private enterprise engaged in the production of plastic and metal items. With years of rapod developing, our products now fall into categories of Flashlight Tool Set, Tool Set , Hand Tool Set, Screwdrivers, gifts, flashlight, house ware, and etc...They are exported to countries and regions over the world, like USA, Europe, Australia, HK..., and enjoy reputations from the customers for the quality and timely delivery.
Homeuse Tool Set,Car Repair Tool Set,Mini Accessory Tool Set,Hand Combination Tool Set Cixi Jinfeng Plastics Co.,Ltd , https://www.nbjftoolkit.com
Solenoid valve failure and troubleshooting
Solenoid valve failure and troubleshooting: Solenoid valve failure will directly affect the switching valve and the control valve action, the common fault solenoid valve does not act, should be investigated from the following aspects: 1, solenoid valve loose or loose head lug, Solenoid valve can not be electric, can tighten the thread. 2, Solenoid coil burned out, you can remove the solenoid valve wiring, with a multimeter to measure, if the open circuit, the solenoid valve coil burned out. The reason is the coil damp, resulting in poor insulation and leakage flux, causing the coil current is too large and burned, so to prevent rain into the solenoid valve. In addition, the spring is too strong, the reaction force is too large, the number of coil turns is too small, and the suction is insufficient, the coil can also be burned. In emergency, the manual button on the coil can be turned to "1" position by the "0" bit during normal operation, so that the valve is opened. 3, solenoid valve stuck. Solenoid valve sleeve and valve spool with a very small gap (less than 0.008mm), are generally a single assembly, when mechanical impurities into or too little oil, it is easy to get stuck. Approach can be used steel wire from the hole into the head, make it bounce. The fundamental solution is to remove the solenoid valve, remove the valve plug and spool sleeve, with CCI4 cleaning, making the spool movement in the valve sleeve flexibility. Disassembly should pay attention to the assembly sequence and the location of external wiring in order to reassemble and wiring properly, but also check the oil mist hole is blocked, the lubricating oil is sufficient. 4, leak. Leakage will result in insufficient air pressure, making it difficult to open and close the forced valve due to damaged gaskets or slide valve wear caused by several cavity blow-by gas. In dealing with switching system solenoid valve failure, should choose the appropriate time, and so on when the solenoid valve is in power loss processing, if not within a switching gap processing, the switching system can be suspended, calmly deal with. This article Keywords: solenoid valve
Product Design for gift, portable case.
It Including the most popular items.
This product is very easy to be stored at home.