When the car battery is low or there is no electricity and the car cannot be started, drivers should not be too anxious. Here I will talk about three methods that can emergencyly start the battery. You can choose the appropriate method according to your own situation to start, so as to avoid long-term stop and traffic accidents caused by other people's obstacles. Cart start The start-up of trolleys should be one of the most common and most familiar methods for effective emergency start-up of batteries. This is a compelling method and it cannot be used frequently. This is often caused by the use of clutches and engines. Certain damage, if it is an automatic car is to maximize the avoidance of this emergency method. The emergency way to start the cart The first thing we must observe is where the vehicle is parked. The surrounding road conditions are not suitable to start the cart. It is also possible to use the downhill road to increase the speed of the vehicle. The car should turn on the ignition before it is pushed. After the vehicle has reached the right speed, it will be in the stall and then release the clutch pedal immediately. If the engine has been started, you should quickly depress the clutch pedal, control the throttle, do not turn off the engine, and finally slowly parked the car in the right place. Battery lap start If everyone is in this sudden situation and there is a companion vehicle, and the trunk is equipped with a jumper cable, it is possible to start the car using the battery lap method. The first is to be able to determine that the position between the two vehicles is close enough, and there is a cable that is absolutely enough to receive and have an insulating sheath, and the positive and negative electrodes of the two batteries are connected in sequence. At this time we must pay attention to the battery positive and negative pole absolutely do not take the wrong, but also enough to ensure that the computer is a reliable connection. In order to avoid the tapes and cables and fans during the start-up, the cables are placed. After splicing is completed, all auxiliary power equipment on the vehicle should be turned off. The use of the battery for starting the power supply of the battery should be started to allow the engine to operate for a few minutes to ensure sufficient amount of power. Finally, in the normal way described before to start the car without electricity, after the start should be slightly stepped on the accelerator pedal, let the engine run at 2000r/min revolutions for a few minutes. At the end of the day, everyone turned off the ignition switch of the two vehicles, and took care when removing the cables to prevent the cable connectors from reaching the positive and negative poles from colliding with each other. Traction start The way in which the traction starts is the same as the principle of the first type of cart, but the difference is that the use of vehicle traction is a relatively easy task. In the use of this method should use a suitable length of traction rope, and to tie the two ends of the rope, when the shadows are carried out, the driver of the front and rear vehicles should be in advance to confirm the contact signal of each other. , for example, whether it is gesturing or whistle while parking or starting? So that both parties can better cooperate. At the beginning, the driver should move forward slowly. The driver who drives in front of the car should not only pay attention to the movement of the rear car, but also pay attention to observing the traffic conditions on the front road at any time. (Text | Sun Ni) Oxygen Sensor For Maserati,Maserati Oxygen Sensor,Maserati O2 Sensor,Maserati Sensor RUIAN XIANGTAI AUTOMOTIVE PARTS CO ., LTD , https://www.raxiangtais.com