Horizontal Heavy Duty Abrasion Resistant Mineral Processing Centrifugal Ah Slurry Pump, Anti-Abrasive Wear Resistant Industrial Chemical Water Mining Pump

1. Flow rate:Q=10~5000(m³/h)
2. Total head:H=20~120 (m)
3. Speed:n=490~2900rpm
4. S.g.:γ ≤1.5 
5. Temperature:T=0~120ºC 
6. Pump diameter:50~450mm

1. Optimized solid and liquid hydraulic model design of high efficiency and energy-saving.
2. Thickened wetted parts design to improve the anti-abrasive ability and prolong pump life.
3. Heavy duty shaft design,with better performance in strength.
4. Reasonable bearing configuration and fully lubricated design ensures the long time and continuous operation.
5. Suitable to pump corrosive or abrasive slurries contains solids,the mixture density of solids and liquid can be up to 60%. 
6. Various sealing types to meet different requirements.
7. According to the requirements of clients,it can work in series.

1. Axial split bracket and double layer casing structure.
2. Outer casing is vertical split structure;pump outlet is able to be set on 8 different direction at 45° interval.
3. Horizontal installation of big loading capacity.
4. The jacket and guard plate as the lining,pump casing and pump cover is the frame.
5. Shaft sealings: dynamic seal,packing seal and mechanical seal.
6. Transmission: Direct coupled,V-belt drive,variable frequency drive,hydraulic coupling.

Structure drawing is as below

1. Bearing box 2. Bracket cover 3. Vice impeller chamber 4. Pump casing 5. Back guard board 6. Outlet pipe 
7. Jacket 8. Impeller 9. Pump cover 10. Inlet pipe 11. Front guard board 12. Vice impeller 13. Bracket 14. Shaft

Configuration:

1. Mineral separation and tailings slurry conveying.
2. Slurry conveying during the producing process of aluminum oxide.
3. Conveying sewage contains solids in industries of thermal power,cement,steel,non-ferrous metal...
4. Sewage and slurry conveying of other industries.

U-tube

U-tube refers to a heat exchange tube shaped like a U, which is an important part of a U Type heat exchanger. Advantages of U-shaped tube: The U-shaped tube heat exchanger has only one tube plate, both ends of the tube are fixed on the same tube plate, the tube can be stretched freely, no thermal stress, and the thermal compensation performance is good; the tube side adopts double tube side, The process is longer, the flow rate is higher, the heat transfer performance is better, and the pressure bearing capacity is strong. The tube bundle can be drawn out from the shell, which is convenient for maintenance and cleaning, and the structure is simple and the cost is cheap. The disadvantage of the U-shaped tube is that due to the limitation of the radius of curvature of the bend tube, the arrangement of the heat exchange tubes is less, the innermost tube spacing of the tube bundle is relatively large, the utilization rate of the Tube Sheet is low, and the shell-side fluid is easy to form a short circuit, which is harmful to the transmission. When the tubes are leaked and damaged, only the U-shaped tubes at the periphery of the tube bundle are easy to replace. If the inner heat exchange tube is damaged, it cannot be replaced, but can only be blocked. Moreover, one damaged U-shaped tube is equivalent to two damaged tubes, and the scrap rate is relatively high.

U-tube,U Shaped Tube,Bundle Tubes,U Tube Bundle

Guangdong Jiema Energy Saving Technology Co.,Ltd , https://www.jiemaheatexchanger.com