What should you pay attention to when the flotation column is parked?

When the flotation column is driving, the air is first supplied to the inflation tube.

After checking the problem, add water to the column. After the water covers the gas tube, open the gate of the tailings connection pipe and see that the water can flow out before it can be fed.

At the same time, the water supply is stopped, and the tailings gate is slightly opened to form a tailings stream. As the slurry level rises, the tailings gate also gradually opens.

When it is found that there is concentrate foam production in the overflow trough, the tailings gate should be carefully adjusted to balance the tailings discharge and the ore-mining amount to maintain the liquid level stability.

When the flotation column is parked, the mine should be stopped first, and the tailings gate should be properly closed and injected with clean water. After removing the mineralized foam by adding water, stop the water injection.

Open the tailings door, open the slurry, rinse with water (mainly to avoid the pores of the air tube blocked), and then stop the wind.

In the event of accident parking (including sudden power outage), the operator should immediately open all the tailings gates, close the feeding pipes, and quickly discharge the slurry in the column, then rinse the air pipes with clean water.

PTA Powder

Main application:Repair and strengthen workpiece surface, significantly

Welding method:PTA welding

Main equipment:PTA welding machine

Flame core temperature: about 10000℃

Technological characteristics:PTA has high temperature, concentrated energy, stable combustion, small heat affected zone, fast welding speed, high production efficiency, easy to obtain low dilution rate of surfacing layer, surfacing layer and workpiece matrix are metallurgical bonding,, bonding strength is high.

Gpni0105b X100

PTA welding technology is one of surface strengthening methods, which has high deposition rate, low dilution rate, and could be applied with many kinds of powder. The manufacturing craft of PTA powder is normally gas atomization, which reduces satellite of powder. We supply 4 main categories of PTA powder: Nickel-based alloy powder, Iron-based alloy powder, Cobalt-based alloy powder and Mixed Powder.

Nickel Based Alloy Powder possesses high temperature resistance and wear resistance, it is the most popular alloy powder applied by PTA welding both domestically and internationally. Coating hardness is within the range of HRC 30-60. It could be applied to various industries like agriculture, plastic, paper, marine and steel making where wear and corrosion protection needed. Some examples are plunger, moulds, pump leaf and screw.

Iron Based Alloy Powder is more widely used and a more economic choice. With high abrasive resistance, it is more commonly applied to mining tools, drilling tools and mixers of iron and steel making industry, coal industry, shaft, oil and energy industry.

Cobalt Based Alloy Powder is recommended for corrosion and oxidation resistance, with better hot hardness values than equivalent Nickel based alloy powder. It is widely applied to steel making industry, coal industry and mining industry.

Mixed powder mainly refers to NiCrBSi mixing with other hard-phase powder such as cast tungsten carbide and other cemented alloy powder, which allows the powder better hardness around HRC60 and excellent abrasion resistance.

Mixed powder is more often used for mining equipment for oil sands, lignite, oil drilling tools, excavator buckets, extrusion screws for plastic processing, grain and oil processing, etc.

PTA Powder,Iron Based Alloy Powder,Cobalt Based Alloy Powder,Nickel Based Alloy Powder

Luoyang Golden Egret Geotools Co., Ltd , https://www.xtccarbide.com