Especially in today’s society, our country and local authorities have put forward very clear requirements for environmental treatment, and we must no longer develop our economy at the expense of our ecological environment. In recent years, we have stepped up environmental management, returning farmland to forests, road dustfall, and urban afforestation work in a very stressful and orderly manner. With regard to urban road dust reduction and urban landscaping work, our green spray trucks have really made a great deal of progress. contribution. However, it is not difficult for us to find that in the yard of the enterprise or the unit, there are many spray cars that have been damaged in a short time. Why is this? In fact, on the one hand, the causes of vehicle wear are on the other hand, a lot of driver friends Without proper use of the sprinkler for work, failure to do the work required resulted in serious damage to many vehicles. Today Xiao Bian consulted with the manufacturer and consulted some of the information, and summed up some of the notes on the use of green sprayer to share with everyone. 1. In fact, our water pump for greening and spraying vehicles is divided into two types. The first one is the clean water pump. The water pump cannot operate in the area where there can be no impurities in the water source, and the other is the turbid water pump of the equipment. The water pump absorbs water. There should be no stone blocks and lots of silt in the water source. 2, for the use of centrifugal pump before each water must be added to some water diversion, and after adding the prompt closing the water inlet; 3, on the greening sprayer suction or spray operation before the power take off device must be in the case of the vehicle to stop the operation; 4. According to different road sections and roads with different widths, we can choose to adjust the spray angle for operation; 5. The remaining water of the tank must be promptly discharged after use, and the vehicle is parked in a cool and dry place, which can effectively reduce the degree of rust in the tank and the surface of the tank; 6. When the temperature is lower than zero, the water in the tank must be eliminated to prevent the freezing and freezing of the pipeline system and other components; 7. In the process of using, add the lubricant to the transmission parts and connecting points regularly to ensure normal operation; 8. Greening sprinkler storage tanks and filters must be regularly cleaned of debris to prevent pipe blockage. The above are some of the basic issues that need to be taken into account during the use of the greening sprayer . I hope everyone can help after reading it.
Stearic Acid, or octadecanoic acid, is produced by the hydrolysis of oils and fats and is mainly used in the production of stearates. It is white waxy transparent solid or slightly yellow waxy solid. Stearic acid is widely used in the manufacture of PVC plastic pipes, plates, profiles and films. It is a PVC heat stabilizer with good lubricity and better light and heat stabilization. In plastic PVC pipes, stearic acid helps prevent "coking" during processing, and is an effective heat stabilizer when added to PVC film processing, as well as defending the finished film from discoloration caused by exposure to sulfide.
Zinc Oxide,Powder Zinc Oxide,White Zinc Oxide Powder,Industrial Zinc Oxide Powder Hebei Fengse New Material Technology Co.ltd. , https://www.fengsechemicals.com