High Speed Rail Brake Block

Specifications

 

 

4. The HGM - A high friction composition brake shoe steel back and friction body two parts.

Brake shoe shape size (mm) :

(1) the steel back of outer arc: R450

(2) brake shoe width: 820-1

(3) the thickness of the brake shoe: 45

 

5. The steel back is made of Q235A steel manufacturing, steel plate performance shall comply with the provisions of GB/T700.

 

6. Brake shoe is made up of steel back and friction.Friction main raw material for: phenolic resin, nitrile rubber, steel fiber,

reduced iron powder, graphite, etc.

 

7. The friction performance component of the learning performance and friction wear performance of two parts.

 

The mechanical properties shall comply with:

Table 1 physical and mechanical performance of the brake shoe

 

Unit performance indicators

G/cm3 density less than nominal worth plus or minus 5%

The compression strength of 25 Mpa or greater

The impact strength acuity 2.0 kJ/m2

The compression modulus of Mpa to 1.3 * 103 or less

Rockwell hardness (HRR) 90 or less

Water absorption percentage < 1.5%

Oil absorption percentage < 1.5%

 

Brake friction wear performance should be consistent with:

Table 2.The change of the instantaneous friction coefficient range (20 kn brake shoe pressure)

Speed (km/h) 0 10 20 30 to 40 50 to 60

The maximum 0.63 0.602 0.558 0.546 0.515 0.482 0.471

Standard 0.48 0.46 0.43 0.42 0.39 0.37 0.36

The minimum 0.42 0.40 0.40 0.36 0.33 0.32 0.37