The medical waste transfer vehicle is classified as a van model, which is a vehicle that specifically consigns waste generated in hospitals. For the use of medical waste transfer vehicles, China has strict rules and regulations and must be implemented in accordance with the rules and regulations when it is used. Before using, please first understand what it needs to pay attention to. First, the medical waste transfer vehicle can only be used for the collection and transportation of medical waste and must not be used for other purposes. Second, when the vehicle is in motion, it is necessary to lock the carriage to ensure safety. It is not allowed to lose or leave and pack medical waste on the way. Third, medical waste transfer vehicles must be equipped with special boxes to prevent the spread of pollution. Special boxes must have: (a) Disinfection equipment and disinfectants; (b) Collection tools and bags; (c) Personnel hygiene protection supplies, etc. Fourth, special emergency vehicles must be kept in good condition at any time, fully equipped. 5. In order to ensure that the medical waste turnover box does not tip over in the event of an emergency start, stop, or accident of the vehicle during non-full-load transportation, the consignee should fix the cargo. 6. After each transfer of the medical waste transfer vehicle is completed, the vehicle body and the compartment must be sterilized immediately at the designated site. The disinfectant should be sealed for at least 30 minutes after spraying. 7. The medical waste transfer vehicle must be cleaned and disinfected every day in the body and compartment. It is forbidden to clean the medical waste transfer vehicle off site. VIII. Medical waste transfer vehicles shall not be allowed to board other unrelated personnel, and may not be loaded or mixed with other goods. Nine, medical waste transfer vehicles to implement a car one card system, do a good job vehicle maintenance, fault repair, driving records and other relevant information for the establishment of card work, and safekeeping. X. Before the medical waste transfer vehicle leaves the vehicle, the driver must check the condition of the vehicle and other facilities to ensure that the vehicle is in good condition. The medical waste transfer vehicle is a special type of special vehicle. It can effectively avoid environmental pollution while transporting waste.
It is mainly used for cooling the hot pellets come out of Pellet Mill. The high temperature 70°C-90°C pellet after cooling is less than 3°C-5°C ambient temperature, and reduce to safe moisture content. The cooling pellets not only increase the pellets hardness but also prevent mildew, eaay for storage and transportation.
The counter flow cooling principle is adopted to cool the pellets with high temperature and high moisture. Hot air touches hot pellets and cool air touches cool pellets so as to avoid the pellet surface crack by shock cooling produced by direct contact between cool air and hot pellets. At the same time, the airclosed airclock is adopted for feeding and bigger air inlet area, therefore it can get better cooling effects.
Cooling Equipment,Granular Material Feed Cooling,Feed Cooling Equipment,Feed Pellet Cooler XinxiangHexie Feed Machienry Manufacturing Co.Ltd , https://www.hxfeedmill.com